Armor All® Shield Snow Foam Car Wash uses a versatile 2-in-1 formula, and can be used with a traditional bucket and sponge, or with a foam gun and pressure washer. Its highly durable, high-foam formula helps create thick foam that adheres to the car's body, allowing it to interact with dirt and break it down. Ideal for use with a traditional bucket and sponge or foam guns and pressure washers. Ultra-durable formula. High foam agents ensure full coverage. The highly adhesive snow foam helps lift dirt and road grime for effective cleaning. Safe for all car finishes including clear coats. Rinse your car to remove excess dirt and grime. Use four cups of Armor All® Shield Foam car wash foam with 5 liters of water for a slightly dirty car, and increase to 8 cups of snow foam for heavily soiled cars. Wash the car in sections using a sponge, glove, or towel. If your car is very dirty, wash it in smaller sections, one area at a time. Rinse the car immediately and thoroughly with water. Dry with a clean, soft microfiber cloth, towel, or chamois to avoid water spots. If using a snow foam gun: rinse your car with water to remove excess dirt and grime. Prepare the snow foam gun according to the manufacturer's instructions and fill the tank with Armor All® Shield Snow Foam car wash. Do not dilute. Turn on the pressure washer and adjust the spray pattern as needed. Working from top to bottom, cover the entire surface of the car with snow foam. Move the glove or sponge before rinsing with clean water to ensure a thorough wash. Repeat these steps if your car is very dirty. Once rinsed, dry the car with a soft, clean microfiber cloth, towel, or chamois to prevent water spots. For best results: use on a cool surface away from direct sunlight.